Wrench

ID	`logistics:tool/wrench`
Type	Tool
Stackable	No
Function	Configuration
Added	v0.1.0

Wrench¶

The Wrench is a configuration tool for pipes, engines, and machines. Use it to rotate output faces, select extraction directions, open filter GUIs, and reset overheated engines.

Recipe¶

→

Yields: 1× Wrench

Usage¶

Right-click blocks with the wrench to configure them. Different blocks respond differently:

Pipe Configuration¶

Item Merger Pipe: - Cycles output direction - Output face marked with opaque connector - Items exit only through configured direction

Item Extractor Pipe: - Cycles extraction face - Active face marked with opaque connector - Only one face extracts at a time

Item Filter Pipe: - Opens filter configuration GUI - Set which items route to which faces - Configure per-side filters

Engine Configuration¶

Redstone Engine / Stirling Engine: - Rotates RF output face - Output face must touch machine input - Position engine correctly for power transfer

Stirling Engine overheat reset: - Right-click overheated engine to reset - Allows engine to cool and restart - Required after overheat shutdown

Other Blocks¶

The wrench works with any configurable Logistics block. Future machines and components will use the wrench for configuration.

Tips¶

Keep wrench in hotbar for quick configuration
Output faces shown with opaque connectors
Right-click to cycle through options
Filter pipes open GUI instead of cycling
Essential tool for building complex networks
Non-destructive - doesn't break blocks (sneak to break normally)

Common Tasks¶

Configure merger output:

Right-click [Item Merger Pipe] → output direction cycles

Select extraction face:

Right-click [Item Extractor Pipe] → extraction face cycles

Open filter GUI:

Right-click [Item Filter Pipe] → GUI opens for configuration

Rotate engine:

Right-click [Engine] → output face rotates

Reset overheated engine:

Right-click [Stirling Engine] (overheated) → resets temperature